How long does a ridge preservation procedure take?
The extraction of the tooth and the placement of the regenerative materials takes approximately 60 minutes. Naturally, the exact length of time will vary from case to case. The stitches are removed 7-10 days later in a 10 minute visit. One or two ten minute check-up visits may be scheduled to ensure the area has healed correctly, and an x-ray will be taken a few months later to evaluate the amount of new bone growth.
Will the ridge preservation procedure hurt?
Only "novocaine" is necessary to perform an extraction and ridge preservation procedure. During the visit you feel nothing since the area is numb. When the "novocaine" wears off, there will be some mild discomfort. Medication will be prescribed to control any discomfort you might experience. This procedure will not cause you to miss work, etc.
Does the barrier which has been placed to accomplish the ridge preservation remain in my mouth?
If a dissolving type of membrane is utilized, it will be gone a few weeks after the procedure. If a non-dissolving barrier is used, it will be removed in a minor procedure which takes 15 minutes.
What is the cost of the procedure?
The cost of the ridge preservation procedure will vary with the situation. However, Dr. DiGiallorenzo will ensure that this matter is discussed with you thoroughly before proceeding with any treatment.
How well does a ridge preservation procedure work?
The ridge preservation procedure is very predictable. The procedure rebuilds damaged bone, resulting in improved esthetics, continued health of the adjacent teeth, and the establishment of adequate bone for implant placement, if necessary.
